Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Specifies the location of the custom HTML file to use
in place of the default login expired page.
ip admission proxy http login expired page file
device:expired-filename
Example:
Switch(config)# ip admission proxy http login
Step 6
expired page file disk1:expired.htm
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 7
Specifying a Redirection URL for Successful Login
Follow these steps to specify a URL to which the user is redirected after authentication, effectively replacing
the internal Success HTML page:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ip admission proxy http success redirect url-string
4.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password
if prompted.
enable
Example:
Switch> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1440
How to Configure Web-Based Authentication

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000