Cisco Catalyst 2960 Series

SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ip device tracking
4.
interface interface-id
5.
switchport mode access
6.
switchport access vlan vlan-id
7.
ip verify source[tracking] [mac-check ]
8.
ip device tracking maximum number
9.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Switch> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Turns on the IP host table, and globally enables IP device
tracking.
ip device tracking
Example:
Switch(config)# ip device tracking
Step 3
Enters interface configuration mode.
interface interface-id
Example:
Switch(config)# interface gigabitethernet
Step 4
1/0/1
Configures a port as access.switchport mode access
Example:
Switch(config-if)# switchport mode access
Step 5
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1296
How to Configure IP Source Guard