Cisco Catalyst 2960 Series User Manual

Subevent Arguments
(Mandatory) Specifies the cache or field attribute to
be monitored. One of the following attributes can be
specified:
•
counter {bytes | packets}--Specifies the
counter fields.
•
datalink {dot1q | mac}--Specifies the datalink
(layer2) fields.
•
flow {direction | sampler}--Specifies the flow
identifying fields.
•
interface {input | output}--Specifies the
interface fields.
•
ipv4 field-type-- Specifies the IPv4 fields.
•
ipv6 field-type-- IPv6 fields
•
routing routing-attrribute -- Specifies the
routing attributes.
•
timestamp sysuptime {first | last}--Specifies
the timestamp fields.
•
transport field-type-- Specifies the Transport
layer fields.
field
(Mandatory) Specifies the rate interval value in
seconds used to calculate the rate. This field is only
valid for event1.
rate_interval
(Mandatory) Specifies the field or rate value.entry_value
(Mandatory) Specifies the field operator.
The comparison operator valid values are:
•
eq - Equal to
•
ge - Greater than or equal to
•
gt - Greater than
•
le - Less than or equal to
•
lt - Less than
•
wc - Wildcard
entry_op
(Optional) The value at which the event is rearmed
to be monitored again.
exit_value
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1912
event_register_nf

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000