Cisco Catalyst 2960 Series User Manual

CHAPTER 24
Configuring Simple Network Management
Protocol
•
Finding Feature Information, page 445
•
Prerequisites for SNMP, page 445
•
Restrictions for SNMP, page 448
•
Information About SNMP, page 448
•
How to Configure SNMP, page 452
•
Monitoring SNMP Status, page 467
•
SNMP Examples, page 468
•
Additional References, page 469
•
Feature History and Information for Simple Network Management Protocol, page 470
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for SNMP
Supported SNMP Versions
This software release supports the following SNMP versions:
• SNMPv1—The Simple Network Management Protocol, a Full Internet Standard, defined in RFC 1157.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
445

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000