Cisco Catalyst 2960 Series User Manual

DSCP ValueIP Precedence Value
567
Related Topics
Default Mapping Table Configuration, on page 568
Configuring the IP-Precedence-to-DSCP Map, on page 606
Configuring the Policed-DSCP Map, on page 607
Default DSCP-to-CoS Map
You use the DSCP-to-CoS map to generate a CoS value, which is used to select one of the four egress queues.
The following table shows the default DSCP-to-CoS map. If these values are not appropriate for your network,
you need to modify them.
Table 72: Default DSCP-to-CoS Map
CoS ValueDSCP Value
0
0–7
1
8–15
2
16–23
3
24–31
4
32–39
5
40–47
6
48–55
7
56–63
Related Topics
Default Mapping Table Configuration, on page 568
Configuring the DSCP-to-CoS Map, on page 608
Configuring the Policed-DSCP Map, on page 607
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
570
Information About QoS

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000