CHAPTER 28
Configuring Auto-QoS
•
Finding Feature Information, page 645
•
Prerequisites for Auto-QoS, page 645
•
Restrictions for Auto-QoS, page 646
•
Information about Configuring Auto-QoS, page 646
•
How to Configure Auto-QoS, page 651
•
Monitoring Auto-QoS, page 655
•
Configuration Examples for Auto-Qos, page 655
•
Where to Go Next for Auto-QoS, page 665
•
Additional References for Auto-QoS, page 665
•
Feature History and Information for Auto-QoS, page 666
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for Auto-QoS
Before configuring standard QoS or auto-QoS, you must have a thorough understanding of these items:
•
The types of applications used and the traffic patterns on your network.
•
Traffic characteristics and needs of your network. Is the traffic bursty? Do you need to reserve bandwidth
for voice and video streams?
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
645
To Next Page
Loading...
