PurposeCommand or Action
Example:
Device(config-applet)# event snmp oid
Example:
1.3.6.1.4.1.9.9.48.1.1.1.6.1 get-type exact
Example:
entry-op lt entry-val 5120000 poll-interval 90
Specifies the type of get operation to perform.
action label info type snmp oid oid-value get-type {exact|
next} [community community-string] [ipaddr ip-address]
Step 5
•
In this example, the type of get operation is
specified as exact and community string is
specified as public.
Example:
Device(config-applet)# action 1.3 info type
Example:
snmp oid 1.3.6.1.4.1.9.9.48.1.1.1.6.1 get-type
Example:
exact community public ipaddr 172.17.16.69
(Optional) Specifies the variable to be set.
action label info type snmp oid oid-value set-type oid-type
oid-type-value community community-string [ipaddr
ip-address]
Step 6
•
In this example, the sysName.0 variable is
specified for the set operation and community
string is specified as rw.
Example:
Device(config-applet)# action 1.4 info type
For set operation, you must specify the SNMP
community string.
Note
Example:
snmp oid 1.3.6.1.4.1.9.9.48.1.1.1.6.1 set-type
Example:
integer 42220 sysName.0 community rw ipaddr
Example:
172.17.16.69
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1728
How to Write EEM Policies Using the Cisco IOS CLI
To Next Page
Loading...
