CHAPTER 60
Auto Identity
•
Auto Identity, page 1453
Auto Identity
The Auto Identity feature provides a set of built-in policies at global configuration and interface configuration
modes. This feature is available only in Class-Based Policy Language (CPL) control policy-equivalent new-style
mode. To convert all the relevant authentication commands to their CPL control policy-equivalents, use the
authentication convert-to new-style command.
This module describes the feature and explains how to configure it.
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Information About Auto Identity
Auto Identity Overview
The Cisco Identity-Based Networking Services (IBNS) solution provides a policy and identity-based framework
in which edge devices can deliver flexible and scalable services to subscribers. IBNS allows the concurrent
operation of IEEE 802.1x (dot1x), MAC authentication bypass (MAB), and web authentication methods,
making it possible to invoke multiple authentication methods in parallel, on a single subscriber session. These
authentication methods, dot1x, authentication, authorization, and accounting (AAA), and RADIUS are available
in global configuration and interface configuration modes.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1453
To Next Page
Loading...
Need help?
General
