Cisco Catalyst 2960 Series User Manual

Feature InformationReleasesFeature Name
The IPv6 PACL feature permits or
denies the movement of traffic
between port-based interface,
Layer 3 subnets, wireless or wired
clients, and VLANs, or within a
VLAN.
This feature was supported on
CAT2960, CAT2960S,
CAT3560X, CAT3650,
CAT3560CX, CAT4500.
The following command was
introduced or modified: ipv6
traffic-filter.
IPv6 PACL Support
Standard IPv6 ACL functionality
was extended to support traffic
filtering based on IPv6 option
headers and optional, upper-layer
protocol type information for finer
granularity of control.
12.2(25)SGIPv6 Services: Extended Access
Control Lists
Access lists determine what traffic
is blocked and what traffic is
forwarded at router interfaces and
allow filtering based on source and
destination addresses, inbound and
outbound to a specific interface.
12.2(25)SGIPv6 Services: Standard Access
Control Lists
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1234
Feature Information for IPv6 Access Control Lists

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000