Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Specifies the TLV to enable.lldp med-tlv-select
Example:
Switch(config-if)# lldp med-tlv-select
Step 4
inventory management
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 5
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 6
Configuring Network-Policy TLV
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
network-policy profile profile number
4.
{voice | voice-signaling} vlan [vlan-id {cos cvalue | dscp dvalue}] | [[dot1p {cos cvalue | dscp dvalue}]
| none | untagged]
5.
exit
6.
interface interface-id
7.
network-policy profile number
8.
lldp med-tlv-select network-policy
9.
end
10.
show network-policy profile
11.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
67
How to Configure LLDP, LLDP-MED, and Wired Location Service

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000