Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Enters interface configuration mode, and specify the
port to be configured.
interface interface-id
Example:
Switch(config)# interface gigabitethernet1/0/2
Step 2
Resets the 802.1x parameters to the default values.dot1x default
Example:
Switch(config-if)# dot1x default
Step 3
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 4
Monitoring 802.1x Statistics and Status
Table 127: Privileged EXEC show Commands
PurposeCommand
Displays 802.1x statistics for all portsshow dot1x all statistics
Displays 802.1x statistics for a specific port
show dot1x interface interface-id statistics
Displays the 802.1x administrative and operational
status for a switch
show dot1x all [count | details | statistics |
summary]
Displays the 802.1x administrative and operational
status for a specific port
show dot1x interface interface-id
Table 128: Global Configuration Commands
PurposeCommand
Filters verbose 802.1x authentication messages
(beginning with Cisco IOS Release 12.2(55)SE)
no dot1x logging verbose
For detailed information about the fields in these displays, see the command reference for this release.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1411
Monitoring 802.1x Statistics and Status

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000