PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 3
(Optional) Saves your entries in the configuration
file.
copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 4
If you are removing a provisioned switch in a stack with this configuration:
•
The stack has four members
•
Stack member 1 is the active switchstack master
•
Stack member 3 is a provisioned switch
and want to remove the provisioned information and to avoid receiving an error message, you can remove
power from stack member 3, disconnect the StackWise-480stack cables between the stack member 3 and
switches to which it is connected, reconnect the cables between the remaining stack members, and enter the
no switch stack-member-number provision global configuration command.
Troubleshooting the Switch Stack
Accessing the CLI of a Specific Member
This optional task is for debugging purposes, and is available only from the active switchstack master.
You can access all or specific members by using the remote command {all | stack-member-number} privileged
EXEC command. The stack member number range is 1 to 8.
You can access specific members by using the session stack-member-number privileged EXEC command.
The member number is appended to the system prompt. For example, the prompt for member 2 is Switch-2#,
and system prompt for the active switchstack master is Switch#. Enter exit to return to the CLI session on the
active switchstack master. Only the show and debug commands are available on a specific member.
Temporarily Disabling a Stack Port
If a stack port is flapping and causing instability in the stack ring, to disable the port, enter the switch
stack-member-number stack port port-number disable privileged EXEC command. To reenable the port,
enter the switch stack-member-number stack port port-number enable command.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
741
Troubleshooting the Switch Stack
To Next Page
Loading...
