CHAPTER 19
Configuring Link-State Tracking
•
Finding Feature Information, page 365
•
Restrictions for Configuring Link-State Tracking, page 365
•
Understanding Link-State Tracking, page 366
•
How to Configure Link-State Tracking , page 369
•
Monitoring Link-State Tracking, page 370
•
Configuring Link-State Tracking: Example, page 370
•
Additional References for Link-State Tracking, page 371
•
Feature Information for Link-State Tracking, page 372
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Restrictions for Configuring Link-State Tracking
•
This feature is supported only on the LAN Base image.
•
You can configure only two link-state groups per switch.
•
An interface cannot be a member of more than one link-state group.
•
An interface that is defined as an upstream interface in a link-state group cannot also be defined as a
downstream interface in the link-state group.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
365
To Next Page
Loading...
Need help?
General
