Cisco Catalyst 2960 Series User Manual

CHAPTER 81
EEM System Information Tcl Command
Extensions
The following conventions are used for the syntax documented on the Tcl command extension pages:
•
An optional argument is shown within square brackets, for example:
[type ?]
•
A question mark ? represents a variable to be entered.
•
Choices between arguments are represented by pipes, for example:
priority low|normal|high
All EEM system information commands--sys_reqinfo_xxx--have the Set _cerrno section set to yes.Note
For all EEM Tcl command extensions, if there is an error, the returned Tcl result string contains the error
information.
Note
Arguments for which no numeric range is specified take an integer from -2147483648 to 2147483647,
inclusive.
Note
•
sys_reqinfo_cli_freq, page 1996
•
sys_reqinfo_cli_history, page 1997
•
sys_reqinfo_cpu_all, page 1998
•
sys_reqinfo_crash_history, page 1999
•
sys_reqinfo_mem_all, page 2000
•
sys_reqinfo_proc, page 2002
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1995

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000