EasyManuals Logo

Cisco Catalyst 2960 Series User Manual

Cisco Catalyst 2960 Series
2288 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #671 background imageLoading...
Page #671 background image
PurposeCommand or Action
Example:
Switch(config-ipv6-acl)#
Enter any as an abbreviation for the IPv6 prefix ::/0.
For host source-ipv6-address or destination-ipv6-address, enter the source
or destination IPv6 host address for which to set deny or permit conditions,
specified in hexadecimal using 16-bit values between colons.
permit ip host 10::1 host
11::2 host
(Optional) For operator, specify an operand that compares the source or
destination ports of the specified protocol. Operands are lt (less than), gt
(greater than), eq (equal), neq (not equal), and range.
If the operator follows the source-ipv6-prefix/prefix-length argument, it
must match the source port. If the operator follows the destination-ipv6-
prefix/prefix-length argument, it must match the destination port.
(Optional) The port-number is a decimal number from 0 to 65535 or the
name of a TCP or UDP port. You can use TCP port names only when
filtering TCP. You can use UDP port names only when filtering UDP.
(Optional) Enter dscp value to match a differentiated services code point
value against the traffic class value in the Traffic Class field of each IPv6
packet header. The acceptable range is from 0 to 63.
(Optional) Enter fragments to check noninitial fragments. This keyword is
visible only if the protocol is IPv6.
(Optional) Enter log to cause a logging message to be sent to the console
about the packet that matches the entry. Enter log-input to include the input
interface in the log entry. Logging is supported only for router ACLs.
(Optional) Enter routing to specify that IPv6 packets be routed.
(Optional) Enter sequence value to specify the sequence number for the
access list statement. The acceptable range is from 1 to 4294967295.
(Optional) Enter time-range name to specify the time range that applies to
the deny or permit statement.
Returns to privileged EXEC mode.end
Example:
Switch(config-ipv6-acl)# end
Step 4
Verifies the access list configuration.show ipv6 access-list
Example:
Switch# show ipv6
Step 5
access-list
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
589
How to Configure QoS

Table of Contents

Other manuals for Cisco Catalyst 2960 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2960 Series and is the answer not in the manual?

Cisco Catalyst 2960 Series Specifications

General IconGeneral
LayerLayer 2
Power over Ethernet (PoE)Available on some models
RAM128 MB
Flash Memory32 MB
MAC Address Table Size8000
Operating Temperature0°C to 45°C (32 to 113°F)
Ports24 or 48 x 10/100/1000

Related product manuals