If you change a location address on the switch, the switch sends an NMSP location notification message that
identifies the affected ports and the changed address information.
Default LLDP Configuration
Table 8: Default LLDP Configuration
Default SettingFeature
DisabledLLDP global state
120 secondsLLDP holdtime (before discarding)
30 secondsLLDP timer (packet update frequency)
2 secondsLLDP reinitialization delay
Disabled to send and receive all TLVsLLDP tlv-select
DisabledLLDP interface state
DisabledLLDP receive
DisabledLLDP transmit
Disabled to send all LLDP-MED TLVs. When LLDP is globally
enabled, LLDP-MED-TLV is also enabled.
LLDP med-tlv-select
Restrictions for LLDP
•
If the interface is configured as a tunnel port, LLDP is automatically disabled.
•
If you first configure a network-policy profile on an interface, you cannot apply the switchport voice
vlan command on the interface. If the switchport voice vlan vlan-id is already configured on an interface,
you can apply a network-policy profile on the interface. This way the interface has the voice or
voice-signaling VLAN network-policy profile applied on the interface.
•
You cannot configure static secure MAC addresses on an interface that has a network-policy profile.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
61
LLDP, LLDP-MED, and Wired Location Service Overview
To Next Page
Loading...
