Cisco Catalyst 2960 Series User Manual

Configuration Examples for Embedded Event Manager Applet
Example Identity Event Detector
The following example shows how a policy named “EventIdentity” is triggered every time the authentication
on the Fast Ethernet interface 0 is success.
event manager applet EventIdentity
event identity interface FastEthernet0 authc success
action 1.0 syslog msg "Applet EventIdentity"
Example MAT Event Detector
The following example shows how a policy named “EventMat” is triggered every time a mac-address is learned
in the mac-address-table.
event manager applet EventMat
event mat interface FastEthernet0
action 1.0 syslog msg "Applet EventMat"
Example Neighbor-Discovery Event Detector
The following example shows how a policy named “EventNeighbor” is triggered when a Cisco Discovery
Protocol (CDP) cache entry changes.
event manager applet EventNeighbor
event neighbor-discovery interface FastEthernet0 cdp all
action 1.0 syslog msg "Applet EventNeighbor"
Embedded Event Manager Manual Policy Execution Examples
The following examples show how to use the none event detector to configure an EEM policy (applet or
script) to be run manually.
Using the event manager run Command
This example shows how to run a policy manually using the event manager run command. The policy is
registered using the event none command under applet configuration mode and then run from global
configuration mode using the event manager run command.
event manager applet manual-policy
event none
action 1.0 syslog msg "Manual-policy triggered"
end
!
event manager run manual-policy
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1749
Configuration Examples for Writing Embedded Event Manager Policies Using Tcl

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000