Cisco Catalyst 2960 Series User Manual

DescriptionEnvironment Variable
The parameters that are passed from the XML SOAP
command to the applet.
_rpc_argc
_rpc_arg0
_rpc_arg1
_rpc_arg2
_rpc_arg3
_rpc_arg4
_rpc_arg5
_rpc_arg6
_rpc_arg7
_rpc_arg8
_rpc_arg9
_rpc_arg10
_rpc_arg11
_rpc_arg12
_rpc_arg13
_rpc_arg14
SNMP Event Detector
A value of 0 indicates that this is not an exit event; a
value of 1 indicates an exit event.
_snmp_exit_event
The SNMP object ID that caused the event to be
published.
_snmp_oid
The actual incremental difference between the value
of the current SNMP object ID and the value when
the event was last triggered.
_snmp_oid_delta_val
The SNMP object ID value when the event was
published.
_snmp_oid_val
SNMP Notification Event Detector
A user specified object ID._snmp_notif_oid
A user specified object ID value._snmp_notif_oid_val
The source IP address of the SNMP Protocol Data
Unit (PDU).
_snmp_notif_src_ip_addr
The destination IP address of the SNMP PDU._snmp_notif_dest_ip_addr
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1691
Information About Writing EEM Policies Using the Cisco IOS CLI

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000