Cisco Catalyst 2960 Series User Manual

TACACS AV Pairs
The network access server implements TACACS+ authorization and accounting functions by transmitting
and receiving TACACS+ attribute-value (AV) pairs for each user session.
TACACS Authentication and Authorization AV Pairs
The following table lists and describes the supported TACACS+ authentication and authorization AV pairs
and specifies the Cisco IOS release in which they are implemented.
Table 86: Supported TACACS+ Authentication and Authorization AV Pairs
12.212.112.011.311.211.111.0DescriptionAttribute
yesyesyesyesyesyesyesASCII
number
representing
a connection
access list.
Used only
when
service=shell.
acl=x
yesyesyesyesyesyesyesA network
address.
Used with
service=slip,
service=ppp,
and
protocol=ip.
Contains the
IP address
that the
remote host
should use
when
connecting
via SLIP or
PPP/IP. For
example,
addr=10.2.3.4.
addr=x
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
780
Information About TACACS+

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000