LAN LiteLAN Base RoutingLAN Base DefaultDefaultResource
0.25.625 K.125 KIPv6 security
ACEs
Related Topics
Examples: Displaying SDM Templates, on page 1594
Setting the SDM Template, on page 1592
SDM Templates and Switch Stacks
All stack members use the same SDM template that is stored on the stack master. When a new switch is added
to a stack, as with the switch configuration and VLAN database files, the SDM configuration that is stored
on the stack master overrides the template configured on an individual switch.
Version-mismatch (VM) mode has priority over SDM-mismatch mode. If a VM mode condition and an
SDM-mismatch mode exist, the switch stack first attempts to resolve the VM-mode condition. You can use
the show switch privileged EXEC command to see if any stack members are in SDM-mismatch mode.
How to Configure SDM Templates
Setting the SDM Template
Follow these steps to use the SDM template to maximize feature usage:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
sdm prefer { default | lanbase-default | lanbase-routing }
4.
sdm prefer { default | dual-ipv4-and-ipv6 {default} | lanbase-routing }
5.
end
6.
reload
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Example:
Switch> enable
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1592
How to Configure SDM Templates
To Next Page
Loading...
Need help?
General
