PurposeCommand or Action
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 11
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 12
startup-config
Configuring Dynamic ARP Inspection in DHCP Environments
Before You Begin
This procedure shows how to configure dynamic ARP inspection when two switches support this feature.
Host 1 is connected to Switch A, and Host 2 is connected to Switch B. Both switches are running dynamic
ARP inspection on VLAN 1 where the hosts are located. A DHCP server is connected to Switch A. Both hosts
acquire their IP addresses from the same DHCP server. Therefore, Switch A has the bindings for Host 1 and
Host 2, and Switch B has the binding for Host 2.
Dynamic ARP inspection depends on the entries in the DHCP snooping binding database to verify
IP-to-MAC address bindings in incoming ARP requests and ARP responses. Make sure to enable DHCP
snooping to permit ARP packets that have dynamically assigned IP addresses.
Note
Follow these steps to configure dynamic ARP inspection. You must perform this procedure on both switches.
This procedure is required.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1308
Configuring Dynamic ARP Inspection in DHCP Environments
To Next Page
Loading...
Need help?
General
