Cisco Catalyst 2960 Series User Manual

Examples: Displaying Service Timestamps Log
This example shows part of a logging display with the service timestamps log datetime global configuration
command enabled:
*Mar 1 18:46:11: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
(Switch-2)
This example shows part of a logging display with the service timestamps log uptime global configuration
command enabled:
00:00:46: %LINK-3-UPDOWN: Interface Port-channel1, changed state to up (Switch-2)
This example shows part of a logging display with the sequence numbers enabled.
000019: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36) (Switch-2)
Additional References for System Message Logs
Related Documents
Document TitleRelated Topic
Catalyst 2960-X Switch System
Management Command Reference
System message log commands
Cisco IOS 15.3M&T Command
References
Platform-independent command references
Cisco IOS 15.3M&T Configuration
Guides
Platform-independent configuration information
Standards and RFCs
TitleStandard/RFC
—
None
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1610
Additional References for System Message Logs

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000