Cisco Catalyst 2960 Series User Manual

(Optional) Policy run-time priority setting. When the
nice argument is set to 1, the policy is run at a
run-time priority that is less than the default priority.
The default value is 0.
nice
Result String
None
Set _cerrno
No
Event_reqinfo
"event_id %u event_type %u event_type_string {%s} %u event_pub_sec %u event_pub_msec %u"
"event_severity {%s} name {%s} parameter {%s} value %d"
DescriptionEvent Type
Unique number that indicates the ID for this published
event. Multiple policies may be run for the same
event, and each policy will have the same event_id.
event_id
Type of event.event_type
An ASCII string that represents the name of the event
for this event type.
event_type_string
The time, in seconds and milliseconds, when the event
was published to the EEM.
event_pub_sec event_pub_msec
Interface event severity, which can be one of the
following values:
•
normal
•
minor
•
major
event_severity
Name of the interface.name
Name of the parameter.parameter
The incremental/decremental difference compared to
the last event triggered or the absolute value of the
parameter being monitored, depending on the
specified value of entry_val_is_increment.
value
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1895
event_register_interface

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000