Cisco Catalyst 2960 Series - Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches

SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface-id
4.
power inline police [action{log | errdisable}]
5.
exit
6.
Use one of the following:
•
errdisable detect cause inline-power
•
errdisable recovery cause inline-power
•
errdisable recovery interval interval
7.
exit
8.
Use one of the following:
•
show power inline police
•
show errdisable recovery
9.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Example:
Switch> enable
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Specifies the physical port to be configured, and enter interface
configuration mode.
interface interface-id
Example:
Switch(config)# interface
gigabitethernet2/0/1
Step 3
If the real-time power consumption exceeds the maximum power
allocation on the port, configures the switch to take one of these
actions:
power inline police [action{log | errdisable}]
Example:
Switch(config-if)# power inline police
Step 4
• power inline police—Shuts down the PoE port, turns off power
to it, and puts it in the error-disabled state.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
98
How to Configure PoE