Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
(Optional) Displays the directory to use for storing EEM user
library or policy files.
show event manager directory user [library| policy]
Example:
Device# show event manager directory user
library
Step 2
•
The optional librarykeyword displays the directory to
use for user library files.
•
The optional policykeyword displays the directory to use
for user-defined EEM policies.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 3
Specifies a directory to use for storing user library files or
user-defined EEM policies.
event manager directory user {library path| policy
path}
Step 4
Example:
Device(config)# event manager directory user
library disk0:/user_library
Device(config)# event manager directory user
library bootflash:/user_library
•
Use the pathargument to specify the absolute pathname
to the user directory.
Exits global configuration mode and returns to privileged EXEC
mode.
exit
Example:
Device(config)# exit
Step 5
Examples
In the following example, the show event manager directory user privileged EXEC command is used to
display the directory, if it exists, to use for storing EEM user library files:
Device# show event manager directory user library
disk0:/user_library
Device# show event manager directory user library
bootflash:/user_library
Modifying History Table Size and Displaying EEM History Data
Perform this optional task to change the size of the history tables and to display EEM history data.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1779
How to Write Embedded Event Manager Policies Using Tcl

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000