PurposeCommand or Action
(Optional) Defines the maximum time to wait for IGMP report
memberships on a receiver port before removing the port from multicast
mvr querytime value
Example:
Switch(config)# mvr querytime
Step 5
group membership. The value is in units of tenths of a second. The range
is 1 to 100, and the default is 5 tenths or one-half second.
10
(Optional) Specifies the VLAN in which multicast data is received; all
source ports must belong to this VLAN. The VLAN range is 1 to 1001
and 1006 to 4094. The default is VLAN 1.
mvr vlan vlan-id
Example:
Switch(config)# mvr vlan 22
Step 6
(Optional) Specifies the MVR mode of operation:mvr mode {dynamic | compatible}
Step 7
Example:
Switch(config)# mvr mode
• dynamic—Allows dynamic MVR membership on source ports.
• compatible—Is compatible with Catalyst 3500 XL and Catalyst 2900
XL switches and does not support IGMP dynamic joins on source
ports.
dynamic
The default is compatible mode.
To return the switch to its default settings, use the no mvr [mode
| group ip-address | querytime | vlan] global configuration
commands.
Note
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 8
Verifies the configuration.Use one of the following:
Step 9
•
show mvr
•
show mvr members
Example:
Switch# show mvr
OR
Switch# show mvr members
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 10
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
148
How to Configure IGMP Snooping and MVR