Cisco Catalyst 2960 Series User Manual

SUMMARY STEPS
1.
configure terminal
2.
cisp enable
3.
dot1x credentials profile
4.
username suppswitch
5.
password password
6.
dot1x supplicant force-multicast
7.
interface interface-id
8.
switchport trunk encapsulation dot1q
9.
switchport mode trunk
10.
dot1x pae supplicant
11.
dot1x credentials profile-name
12.
end
13.
show running-config interface interface-id
14.
copy running-config startup-config
15.
Configuring NEAT with Auto Smartports Macros
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Enables CISP.cisp enable
Example:
Switch(config)# cisp enable
Step 2
Creates 802.1x credentials profile. This must be attached
to the port that is configured as supplicant.
dot1x credentials profile
Example:
Switch(config)# dot1x credentials test
Step 3
Creates a username.
username suppswitch
Example:
Switch(config)# username suppswitch
Step 4
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1398
How to Configure 802.1x Port-Based Authentication

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000