Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Enables filtering of Router Advertisement messages by the Router
Preference flag. If not configured, this filter is disabled.
[no]router-preference maximum {high |
medium | low}
Step 8
Example:
Switch(config-nd-raguard)#
router-preference maximum high
• high—Accepts RA messages with the Router Preference set to
high, medium, or low.
• medium—Blocks RA messages with the Router Preference set
to high.
• low—Blocks RA messages with the Router Preference set to
medium and high.
When configured as a trusted port, all attached devices are trusted,
and no further message verification is performed.
[no]trusted-port
Example:
Switch(config-nd-raguard)# trusted-port
Step 9
Restores a command to its default value.default {device-role | hop-limit {maximum |
minimum} | managed-config-flag | match {ipv6
Step 10
access-list | ra prefix-list } | other-config-flag |
router-preference maximum| trusted-port}
Example:
Switch(config-nd-raguard)# default
hop-limit
(Optional)—Displays the ND Guard Policy configuration without
exiting the RA Guard policy configuration mode.
do show ipv6 nd raguard policy policy_name
Example:
Switch(config-nd-raguard)# do show ipv6
nd raguard policy example_policy
Step 11
Related Topics
Information about First Hop Security in IPv6, on page 678
How to Attach an IPv6 Router Advertisement Guard Policy to an Interface
Beginning in privileged EXEC mode, follow these steps to attach an IPv6 Router Advertisement policy to an
interface or to VLANs on the interface :
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
697
How to Configure an IPv6 Router Advertisement Guard Policy

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000