PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 5
Related Topics
Specifying the MST Region Configuration and Enabling MSTP , on page 261
Restarting the Protocol Migration Process
This procedure restarts the protocol migration process and forces renegotiation with neighboring switches. It
reverts the switch to MST mode. It is needed when the switch no longer receives IEEE 802.1D BPDUs after
it has been receiving them.
Follow these steps to restart the protocol migration process (force the renegotiation with neighboring switches)
on the switch.
Before You Begin
A multiple spanning tree (MST) must be specified and enabled on the switch. For instructions, see Related
Topics.
If you want to use the interface version of the command, you must also know the MST interface used. This
example uses GigabitEthernet1/0/1 as the interface because that was the interface set up by the instructions
listed under Related Topics.
SUMMARY STEPS
1.
enable
2.
Enter one of the following commands:
•
clear spanning-tree detected-protocols
•
clear spanning-tree detected-protocols interface interface-id
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your
password if prompted.
enable
Example:
Switch> enable
Step 1
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
278
How to Configure MSTP Features
To Next Page
Loading...
Need help?
General
