CHAPTER 66
Configuring SDM Templates
•
Finding Feature Information, page 1589
•
Information About Configuring SDM Templates, page 1589
•
How to Configure SDM Templates, page 1592
•
Configuration Examples for SDM Templates, page 1594
•
Additional References for SDM Templates, page 1595
•
Feature History and Information for Configuring SDM Templates, page 1596
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Information About Configuring SDM Templates
Restrictions for SDM Templates
The following are restrictions when using SDM templates:
•
The default template is the only template supported on switches running the LAN Lite image.
•
The LAN Base default template is used with switches in a homogeneous stack.
•
The LAN Base routing template is supported only on switches running the LAN Base image.
•
The LAN Base routing template is used with switches in a mixed stack.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1589
To Next Page
Loading...
