Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
• recursive—(Optional) Displays only recursive static routes. The recursive
keyword is mutually exclusive with the interface keyword, but it can be
used with or without the IPv6 prefix included in the command syntax.
[interface interface-id ]
[detail]][recursive] [detail]
•
show ipv6 route static [ updated ]
• detail—(Optional) Displays this additional information:
Example:
Switch# show ipv6 static
2001:0DB8::/32 interface
◦
For valid recursive routes, the output path set, and maximum resolution
depth.
◦
For invalid routes, the reason why the route is not valid.
gigabitethernet2/0/1
or
Switch# show ipv6 route static
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 5
startup-config
Displaying IPv6
For complete syntax and usage information on these commands, see the Cisco IOS command reference
publications.
Table 24: Command for Monitoring IPv6
PurposeCommand
Displays a summary of access lists.show ipv6 access-list
Displays Cisco Express Forwarding for IPv6.show ipv6 cef
Displays IPv6 interface status and configuration.
show ipv6 interfaceinterface-id
Displays IPv6 MTU per destination cache.show ipv6 mtu
Displays IPv6 neighbor cache entries.show ipv6 neighbors
Displays a list of IPv6 prefix lists.show ipv6 prefix-list
Displays a list of IPv6 routing protocols on the switch.show ipv6 protocols
Displays IPv6 RIP routing protocol status.show ipv6 rip
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
195
Information About Configuring IPv6 Host Functions

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000