SupportedTypeAccess List Number
YesIP standard access list (expanded range)
1300–1999
YesIP extended access list (expanded range)
2000–2699
In addition to numbered standard and extended ACLs, you can also create standard and extended named IP
ACLs by using the supported numbers. That is, the name of a standard IP ACL can be 1 to 99; the name of
an extended IP ACL can be 100 to 199. The advantage of using named ACLs instead of numbered lists is that
you can delete individual entries from a named list.
Numbered Standard IPv4 ACLs
When creating an ACL, remember that, by default, the end of the ACL contains an implicit deny statement
for all packets that it did not find a match for before reaching the end. With standard access lists, if you omit
the mask from an associated IP host address ACL specification, 0.0.0.0 is assumed to be the mask.
The switch always rewrites the order of standard access lists so that entries with host matches and entries
with matches having a don’t care mask of 0.0.0.0 are moved to the top of the list, above any entries with
non-zero don’t care masks. Therefore, in show command output and in the configuration file, the ACEs do
not necessarily appear in the order in which they were entered.
After creating a numbered standard IPv4 ACL, you can apply it to VLANs, to terminal lines, or to interfaces.
Numbered Extended IPv4 ACLs
Although standard ACLs use only source addresses for matching, you can use extended ACL source and
destination addresses for matching operations and optional protocol type information for finer granularity of
control. When you are creating ACEs in numbered extended access lists, remember that after you create the
ACL, any additions are placed at the end of the list. You cannot reorder the list or selectively add or remove
ACEs from a numbered list.
The switch does not support dynamic or reflexive access lists. It also does not support filtering based on the
type of service (ToS) minimize-monetary-cost bit.
Some protocols also have specific parameters and keywords that apply to that protocol.
You can define an extended TCP, UDP, ICMP, IGMP, or other IP ACL. The switch also supports these IP
protocols:
ICMP echo-reply cannot be filtered. All other ICMP codes or types can be filtered.Note
These IP protocols are supported:
•
Authentication Header Protocol (ahp)
•
Encapsulation Security Payload (esp)
•
Enhanced Interior Gateway Routing Protocol (eigrp)
•
generic routing encapsulation (gre)
•
Internet Control Message Protocol (icmp)
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1177
Information About Configuring IPv4 Access Control Lists
To Next Page
Loading...
Need help?
General
