Cisco Catalyst 2960 Series User Manual

Reconfirming VLAN Memberships
This task confirms the dynamic-access port VLAN membership assignments that the switch has received from
the VMPS.
SUMMARY STEPS
1.
enable
2.
vmps reconfirm
3.
show vmps
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Switch> enable
Step 1
Reconfirms dynamic-access port VLAN membership.vmps reconfirm
Example:
Switch# vmps reconfirm
Step 2
Verifies the dynamic VLAN reconfirmation status.show vmps
Example:
Switch# show vmps
Step 3
Changing the Reconfirmation Interval
VMPS clients periodically reconfirm the VLAN membership information received from the VMPS. You can
set the number of minutes after which reconfirmation occurs.
If you are configuring a member switch in a cluster, this parameter must be equal to or greater than the
reconfirmation setting on the command switch. You also must first use the rcommand privileged EXEC
command to log in to the member switch.
Note
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
2158
How to Configure VMPS

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000