Default DNS Settings
Table 140: Default DNS Settings
Default SettingFeature
Enabled.DNS enable state
None configured.DNS default domain name
No name server addresses are configured.DNS servers
Login Banners
You can configure a message-of-the-day (MOTD) and a login banner. The MOTD banner is displayed on all
connected terminals at login and is useful for sending messages that affect all network users (such as impending
system shutdowns).
The login banner is also displayed on all connected terminals. It appears after the MOTD banner and before
the login prompts.
For complete syntax and usage information for the commands used in this section, see the Cisco IOS
Configuration Fundamentals Command Reference, Release 12.4.
Note
Default Banner Configuration
The MOTD and login banners are not configured.
MAC Address Table
The MAC address table contains address information that the switch uses to forward traffic between ports.
All MAC addresses in the address table are associated with one or more ports. The address table includes
these types of addresses:
• Dynamic address—A source MAC address that the switch learns and then ages when it is not in use.
• Static address—A manually entered unicast address that does not age and that is not lost when the switch
resets.
The address table lists the destination MAC address, the associated VLAN ID, and port number associated
with the address and the type (static or dynamic).
For complete syntax and usage information for the commands used in this section, see the command
reference for this release.
Note
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1529
Information About Administering the Switch
To Next Page
Loading...
Need help?
General
