Event_reqinfo For EEM_EVENT_IDENTITY
"event_id %u event_type %u event_type_string {%s} event_pub_sec %u event_pub_msec %u
event_severity %u identity_stage %u identity_status %u interface %u identity_mac %u
identity_<attribute> {%s}"
DescriptionEvent Type
Unique number that indicates the ID for this published
event. Multiple policies may be run for the same
event, and each policy will have the same event_id.
event_id
Type of event.event_type
An ASCII string that represents the name of the event
for this event type.
event_type_string
The time, in seconds and milliseconds, at which the
event was published to the EEM.
event_pub_sec event_pub_msec
The severity of the event.event_severity
One among authentication, autherization or
autherization-complete stages.
identity_stage
Success or one of these failure types: fail_authc,
fail_aaa_server, fail_no_response, fail_timeout,
fail_authz. For autherization-complete it is always
success.
identity_status
The interface for the event.interface
The MAC address of the remote device for the event.identity_mac
For each AAA attribute, a set a dynamic variable to
the value corresponding to that AAA attribute in the
attribute or value list.
identity_<attribute>
event_register_interface
Registers for an interface counter event. Use this Tcl command extension to generate an event when specified
interface counters exceed specified thresholds.
Syntax
event_register_interface [tag ?] name ?
parameter ? entry_op gt|ge|eq|ne|lt|le
entry_val ? entry_val_is_increment TRUE|FALSE
entry_type value|increment|rate
[exit_comb or|and]
[exit_op gt|ge|eq|ne|lt|le]
[exit_val ?] [exit_val_is_increment TRUE|FALSE]
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1889
event_register_interface
To Next Page
Loading...
