CHAPTER 34
Controlling Switch Access with Passwords and
Privilege Levels
•
Finding Feature Information, page 755
•
Restrictions for Controlling Switch Access with Passwords and Privileges, page 755
•
Information About Passwords and Privilege Levels, page 756
•
How to Control Switch Access with Passwords and Privilege Levels, page 758
•
Monitoring Switch Access, page 771
•
Configuration Examples for Setting Passwords and Privilege Levels, page 771
•
Additional References, page 773
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Restrictions for Controlling Switch Access with Passwords and Privileges
The following are the restrictions for controlling switch access with passwords and privileges:
•
Disabling password recovery will not work if you have set the switch to boot up manually by using the
boot manual global configuration command. This command produces the boot loader prompt (switch:)
after the switch is power cycled.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
755
To Next Page
Loading...
Need help?
General
