CHAPTER 3
Configuring Auto-MDIX
•
Prerequisites for Auto-MDIX, page 45
•
Restrictions for Auto-MDIX, page 45
•
Information about Configuring Auto-MDIX, page 45
•
How to Configure Auto-MDIX, page 46
•
Example for Configuring Auto-MDIX, page 47
•
Additional References, page 48
•
Feature History and Information for Auto-MDIX, page 48
Prerequisites for Auto-MDIX
Automatic medium-dependent interface crossover (auto-MDIX) is enabled by default.
Auto-MDIX is supported on all 10/100/1000-Mb/s and on 10/100/1000BASE-TX small form-factor pluggable
(SFP)-module interfaces. It is not supported on 1000BASE-SX or -LX SFP module interfaces.
Restrictions for Auto-MDIX
The switch might not support a pre-standard powered device—such as Cisco IP phones and access points that
do not fully support IEEE 802.3af—if that powered device is connected to the switch through a crossover
cable. This is regardless of whether auto-MIDX is enabled on the switch port.
Information about Configuring Auto-MDIX
Auto-MDIX on an Interface
When automatic medium-dependent interface crossover (auto-MDIX) is enabled on an interface, the interface
automatically detects the required cable connection type (straight through or crossover) and configures the
connection appropriately. When connecting switches without the auto-MDIX feature, you must use
straight-through cables to connect to devices such as servers, workstations, or routers and crossover cables
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
45
To Next Page
Loading...
