EasyManua.ls Logo

Cisco Catalyst 2960 Series

Cisco Catalyst 2960 Series
2288 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The IPv6 ACL Extensions for Hop by Hop Filtering feature implements RFC 2460 to support traffic filtering
in any upper-layer protocol type.
How to Configure IPv6 ACLs
Configuring IPv6 ACLs
To filter IPv6 traffic, you perform these steps:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
{ipv6 access-list list-name
4.
{deny | permit} protocol {source-ipv6-prefix/|prefix-length|any| host source-ipv6-address} [ operator [
port-number ]] { destination-ipv6-prefix/ prefix-length | any | host destination-ipv6-address} [operator
[port-number]][dscp value] [fragments] [log] [log-input] [routing] [sequence value] [time-range name]
5.
{deny | permit} tcp {source-ipv6-prefix/prefix-length | any | host source-ipv6-address} [operator
[port-number]] {destination-ipv6- prefix/prefix-length | any | host destination-ipv6-address} [operator
[port-number]] [ack] [dscp value] [established] [fin] [log] [log-input] [neq {port | protocol}] [psh]
[range {port | protocol}] [rst] [routing] [sequence value] [syn] [time-range name] [urg]
6.
{deny | permit} udp {source-ipv6-prefix/prefix-length | any | host source-ipv6-address} [operator
[port-number]] {destination-ipv6-prefix/prefix-length | any | host destination-ipv6-address} [operator
[port-number]] [dscp value] [log] [log-input] [neq {port | protocol}] [range {port | protocol}] [routing]
[sequence value] [time-range name]]
7.
{deny | permit} icmp {source-ipv6-prefix/prefix-length | any | host source-ipv6-address} [operator
[port-number]] {destination-ipv6-prefix/prefix-length | any | host destination-ipv6-address} [operator
[port-number]] [icmp-type [icmp-code] | icmp-message] [dscp value] [log] [log-input] [routing] [sequence
value] [time-range name]
8.
end
9.
show ipv6 access-list
10.
show running-config
11.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Example:
Switch> enable
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1222
How to Configure IPv6 ACLs

Table of Contents

Other manuals for Cisco Catalyst 2960 Series

Related product manuals