Cisco Catalyst 2960 Series User Manual

[consecutive_failure consecutive_failure_number]
[platform_action [action_flag]]
[maxrun ?]
[queue_priority low|normal|high|last]
[nice 0|1]
Arguments
(Mandatory) Specifies whether all cards or one card
is to be monitored:
•
card all--Specifies that all cards are to be
monitored. This is the default.
•
card-number--Specifies that the card identified
by the number card-number is to be monitored.
This argument must be specified to complete the
event_register_goldTcl command extension.
card
(Optional) Specifies that one or more subcards are to
be monitored:
•
subcard all--Specifies that all subcards are to be
monitored.
•
subcard-number--Specifies that the subcard
identified by the number subcard-number is to
be monitored.
If this argument is not specified, all subcards are
monitored by default.
subcard
(Optional) Specifies event criteria based on the new
test failure information from GOLD:
•
new_failure TRUE--Specifies that the event
criterion for the new test failure is true from
GOLD.
•
new_failure FALSE--Specifies that the event
criterion for the new test failure is false from
GOLD.
If this argument is not specified, the new test failure
information from GOLD is not considered in the event
criteria.
new_failure
(Optional) Specifies that the event criteria for
diagnostic result matches with the diagnostic major
error from GOLD.
severity_major
(Optional) Specifies that the event criteria for
diagnostic result matches with diagnostic minor error
from GOLD.
severity_minor
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1880
event_register_gold

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000