PurposeCommand or Action
Example:
Switch> enable
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Specifies the network-policy profile number, and enter network-policy
configuration mode. The range is 1 to 4294967295.
network-policy profile profile number
Example:
Switch(config)# network-policy profile
Step 3
1
Configures the policy attributes:
{voice | voice-signaling} vlan [vlan-id {cos
cvalue | dscp dvalue}] | [[dot1p {cos cvalue |
dscp dvalue}] | none | untagged]
Step 4
• voice—Specifies the voice application type.
Example:
Switch(config-network-policy)# voice vlan
• voice-signaling—Specifies the voice-signaling application type.
• vlan—Specifies the native VLAN for voice traffic.
• vlan-id—(Optional) Specifies the VLAN for voice traffic. The
range is 1 to 4094.
100 cos 4
• cos cvalue—(Optional) Specifies the Layer 2 priority class of
service (CoS) for the configured VLAN. The range is 0 to 7;
the default is 5.
• dscp dvalue—(Optional) Specifies the differentiated services
code point (DSCP) value for the configured VLAN. The range
is 0 to 63; the default is 46.
• dot1p—(Optional) Configures the telephone to use IEEE 802.1p
priority tagging and use VLAN 0 (the native VLAN).
• none—(Optional) Do not instruct the IP telephone about the
voice VLAN. The telephone uses the configuration from the
telephone key pad.
• untagged—(Optional) Configures the telephone to send
untagged voice traffic. This is the default for the telephone.
• untagged—(Optional) Configures the telephone to send
untagged voice traffic. This is the default for the telephone.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
68
How to Configure LLDP, LLDP-MED, and Wired Location Service
To Next Page
Loading...
