Cisco Catalyst 2960 Series User Manual

To disable the Cisco IOS agent, use the no cns config partial { ip-address | hostname } global configuration
command. To cancel a partial configuration, use the cns config cancel global configuration command.
Related Topics
Incremental (Partial) Configuration, on page 413
Monitoring CNS Configurations, on page 427
Monitoring CNS Configurations
Table 44: CNS show Commands
PurposeCommand
Displays the status of the CNS Cisco IOS CNS agent
connections.
show cns config connections
Switch# show cns config connections
Displays information about incremental (partial) CNS
configurations that have started but are not yet
completed.
show cns config outstanding
Switch# show cns config outstanding
Displays statistics about the Cisco IOS CNS agent.show cns config stats
Switch# show cns config stats
Displays the status of the CNS event agent
connections.
show cns event connections
Switch# show cns event connections
Displays the event gateway information for your
switch.
show cns event gateway
Switch# show cns event gateway
Displays statistics about the CNS event agent.show cns event stats
Switch# show cns event stats
Displays a list of event agent subjects that are
subscribed to by applications.
show cns event subject
Switch# show cns event subject
Related Topics
Enabling a Partial Configuration for Cisco IOS CNS Agent, on page 425
Incremental (Partial) Configuration, on page 413
Enabling an Initial Configuration for Cisco IOS CNS Agent, on page 418
Initial Configuration, on page 412
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
427
Monitoring CNS Configurations

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000