Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Example:
Device> enable
•
Enter your password if prompted.
Displays the pending and held EEM policies.show event manager policy pending
Step 2
Example:
Device# show event manager policy pending
Only the syntax applicable to this task is used in this
example. For more details, see the Cisco IOS Network
Management Command Reference.
Note
Resumes execution of specified EEM policies.event manager scheduler release {all | policy
policy-id | queue-type {applet | call-home | axp |
Step 3
•
The example shows how to resume the execution of the
policy with job ID of 2.
script}} class class-options [processor {rp_primary
| rp_standby}]
Example:
Device# event manager scheduler release
policy 2
Displays the status of the EEM policy resumed in Step 3 as
pending, along with other pending policies.
show event manager policy pending
Example:
Device# show event manager policy pending
Step 4
Only the syntax applicable to this task is used in this
example. For more details, see the Cisco IOS Network
Management Command Reference.
Note
Examples
The following example shows how to view all pending EEM policies, to specify the policy that will resume
execution, and to see that the policy is now back in a pending status.
Device# show event manager policy pending
no. job id status time of event event type name
1 1 pend Thu Sep 7 02:54:04 2006 syslog applet: one
2 2 held Thu Sep 7 02:54:04 2006 syslog applet: two
3 3 pend Thu Sep 7 02:54:04 2006 syslog applet: three
Rotuer# event manager scheduler release policy 2
Rotuer# show event manager policy pending
no. job id status time of event event type name
1 1 pend Thu Sep 7 02:54:04 2006 syslog applet: one
2 2 pend Thu Sep 7 02:54:04 2006 syslog applet: two
3 3 pend Thu Sep 7 02:54:04 2006 syslog applet: three
Clearing Pending EEM Policy Events or Event Queues
Perform this task to clear EEM policies that are executing or pending execution. In this task, the EEM policy
with a job ID of 2 is cleared from the pending queue. The show event manager policy pending command
is used to display the policies that are pending before and after the policy is cleared.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1715
How to Write EEM Policies Using the Cisco IOS CLI

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000