Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
(Optional) Configures a range of interfaces.
Interfaces configured in a range must be the same type and must
be configured with the same feature options.
Note
interface range or interface range macro
Step 5
Displays a list of all interfaces on or configured for the switch. A report
is provided for each interface that the device supports or for the specified
interface.
show interfaces
Step 6
Adding a Description for an Interface
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface-id
4.
description string
5.
end
6.
show interfaces interface-id description
7.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password
if prompted.
enable
Example:
Switch> enable
Step 1
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Specifies the interface for which you are adding a
description, and enter interface configuration mode.
interface interface-id
Example:
Switch(config)# interface gigabitethernet1/0/2
Step 3
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
25
How to Configure Interface Characteristics

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000