Cisco Catalyst 2960 Series

Monitoring Web-Based Authentication Status
Use the commands in this topic to display the web-based authentication settings for all interfaces or for specific
ports.
Table 131: Privileged EXEC show Commands
PurposeCommand
Displays the web-based authentication settings for all
interfaces for fastethernet, gigabitethernet, or
tengigabitethernet
show authentication sessions method webauth
Displays the web-based authentication settings for
the specified interface for fastethernet, gigabitethernet,
or tengigabitethernet.
In Session Aware Networking mode, use the show
access-session interface command.
show authentication sessions interface
type slot/port[details]
Displaying Web-Based Authentication Status
Perform this task to display the web-based authentication settings for all interfaces or for specific ports:
SUMMARY STEPS
1.
show authentication sessions {interfacetype/ slot}
DETAILED STEPS
PurposeCommand or Action
Displays the web-based authentication settings.
type = fastethernet, gigabitethernet, or
tengigabitethernet
show authentication sessions {interfacetype/ slot}
Example:
Step 1
This example shows how to view only the global web-based
authentication status:
Switch# show authentication sessions
(Optional) Use the interface keyword to display the
web-based authentication settings for a specific
interface
Example:
This example shows how to view the web-based authentication
settings for gigabit interface 3/27:
Switch# show authentication sessions interface gigabitethernet
3/27
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1447
How to Configure Web-Based Authentication