Cisco Catalyst 2960 Series User Manual

Device# event manager scheduler clear policy 2
Device# show event manager policy pending
no. job id status time of event event type name
1 1 pend Thu Sep 7 02:54:04 2006 syslog applet: one
3 3 pend Thu Sep 7 02:54:04 2006 syslog applet: three
Modifying the Scheduling Parameters of EEM Policy Events or Event Queues
To modify the scheduling parameters of the EEM policies, perform this task. The show event manager policy
pending command displays policies that are assigned to the B or default class. All the currently pending
policies are then changed to class A. After the configuration modification, the show event manager policy
pending command shows all policies assigned as class A.
SUMMARY STEPS
1.
enable
2.
show event manager policy pending
3.
event manager scheduler modify {all | policy job-id | queue-type {applet | call-home | axp | script} |
class class-options} [queue-priority {high | last | low | normal}][processor {rp_primary | rp_standby}]
4.
show event manager policy pending
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Displays the pending EEM policies.show event manager policy pending
Step 2
Example:
Device# show event manager policy pending
Only the syntax applicable to this task is used in this
example. For more details, see the Cisco IOS Network
Management Command Reference.
Note
Modifies the scheduling parameters of the EEM policies.
event manager scheduler modify {all | policy job-id
| queue-type {applet | call-home | axp | script} | class
Step 3
•
In this example, all currently pending EEM policies are
assigned to class A.
class-options} [queue-priority {high | last | low |
normal}][processor {rp_primary | rp_standby}]
Example:
Device# event manager scheduler modify all class
A
Displays the EEM policies modified in Step 3 along with other
pending policies.
show event manager policy pending
Example:
Device# show event manager policy pending
Step 4
Only the syntax applicable to this task is used in this
example. For more details, see the Cisco IOS Network
Management Command Reference.
Note
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1717
How to Write EEM Policies Using the Cisco IOS CLI

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000