PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 4
Verifies your entries.
show authentication sessions interface interface-id
Example:
Switch# show authentication sessions interface
Step 5
gigabitethernet2/0/3
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 6
Configuring MAC Authentication Bypass
Beginning in privileged EXEC mode, follow these steps to enable MAC authentication bypass. This procedure
is optional.
SUMMARY STEPS
1.
configure terminal
2.
interface interface-id
3.
authentication port-control auto
4.
mab [eap]
5.
end
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1388
How to Configure 802.1x Port-Based Authentication
To Next Page
Loading...
