Cisco Catalyst 2960 Series User Manual

(Mandatory) Software Modularity images only. The
pathname of the POSIX process that contains the
Cisco IOS scheduler to be monitored. For example,
/sbin/cdp2.iosproc.
path
(Mandatory) The name of the Cisco IOS task to be
monitored.
taskname
(Mandatory) The comparison operator used to
compare the collected usage sample with the specified
value; if true, an event will be raised.
op
(Mandatory) The value to be compared.val
(Optional) The elapsed time period for the collection
samples to be averaged (specified in
SSSSSSSSSS[.MMM] format, where SSSSSSSSSS
must be an integer representing seconds between 0
and 4294967295, inclusive, and where MMM must
be an integer representing milliseconds between 0
and 999). If this argument is not specified, the most
recent sample is used.
period
(Mandatory) Specifies the use of a sample collection
of memory statistics.
mem_proc
(Optional) Whether the specified value is a
percentage.
is_percent
Result String
None
Set _cerrno
No
Event_reqinfo
"event_id %u event_type %u event_type_string {%s} %u event_pub_sec %u event_pub_msec %u"
"num_subs %u"
DescriptionEvent Type
Unique number that indicates the ID for this published
event. Multiple policies may be run for the same
event, and each policy will have the same event_id.
event_id
Type of event.event_type
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1898
event_register_ioswdsysmon

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000