Example: Configuring NVRAM Buffer Size
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# boot buffersize 600000
Switch(config)# end
Switch# show boot
BOOT path-list :
Config file : flash:/config.text
Private Config file : flash:/private-config.text
Enable Break : no
Manual Boot : no
HELPER path-list :
Auto upgrade : yes
Auto upgrade path :
NVRAM/Config file
buffer size: 600000
Timeout for Config
Download: 300 seconds
Config Download
via DHCP: enabled (next boot: enabled)
Switch#
Related Topics
Configuring the NVRAM Buffer Size, on page 1579
Additional References for Performing Switch Setup
Related Documents
Document TitleRelated Topic
Catalyst 2960-X Switch System
Management Command Reference
Switch setup commands
Boot loader commands
Catalyst 2960-X Switch Interface
and Hardware Component
Configuration Guide
Catalyst 2960-X Switch Managing
Cisco IOS Image Files
Configuration Guide
USB flash devices
Catalyst 2960-X Switch Hardware
Installation Guide
Hardware installation
Cisco IOS 15.3M&T Command
References
Platform-independent command references
Cisco IOS 15.3M&T Configuration
Guides
Platform-independent configuration information
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1586
Additional References for Performing Switch Setup
To Next Page
Loading...
