Cisco Catalyst 2960 Series User Manual

(Optional) The node name to be monitored for
deadlock conditions is a string that consists of the
word "node" followed by two fields separated by a
slash character using the following format:
node<slot-number>/<cpu-number>
The slot-number is the hardware slot number. The
cpu-number is the hardware CPU number. For
example, the SP CPU in a Supervisor card on a Cisco
Catalyst 6500 series switch located in slot 0 would
be specified as node0/0. The RP CPU in a Supervisor
card on a Cisco Catalyst 6500 series switch located
in slot 0 would be addressed as node0/1. If the node
argument is not specified, the default node
specification is the local node on which the
registration is done.
node
(Optional) Priority level at which the script will be
queued:
•
queue_priority low--Specifies that the script is
to be queued at the lowest of the three priority
levels.
•
queue_priority normal--Specifies that the script
is to be queued at a priority level greater than
low priority but less than high priority.
•
queue_priority high--Specifies that the script is
to be queued at the highest of the three priority
levels.
•
queue_priority last--Specifies that the script is
to be queued at the lowest priority level.
If more than one script is registered with the
"queue_priority_last" argument set, these scripts will
execute in the order in which the events are published.
The queue_priority argument specifies the
queuing priority, but not the execution
priority, of the script being registered.
Note
If this argument is not specified, the default queuing
priority is normal.
queue_priority
(Optional) Maximum run time of the script (specified
in SSSSSSSSSS[.MMM] format, where SSSSSSSSSS
must be an integer representing seconds between 0
and 4294967295, inclusive, and where MMM must
be an integer representing milliseconds between 0
and 999). If this argument is not specified, the default
20-second run-time limit is used.
maxrun
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1960
event_register_wdsysmon

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000