Cisco Catalyst 2960 Series

Table 69: Default DSCP Output 8 Queue Threshold Map
4 Egress Queue MappingThreshold IDEgress QueueDSCP
2120-7
2138-15
31416-23
31524-31
41632-39
11140-47
41748-55
41856-63
Related Topics
Enabling QoS Globally, on page 571
Standard QoS Default Configuration, on page 563
Default Mapping Table Configuration
The default DSCP-to-DSCP-mutation map is a null map, which maps an incoming DSCP value to the same
DSCP value.
The default policed-DSCP map is a null map, which maps an incoming DSCP value to the same DSCP value
(no markdown).
Related Topics
Default CoS-to-DSCP Map, on page 568
Default IP-Precedence-to-DSCP Map, on page 569
Default DSCP-to-CoS Map, on page 570
DSCP Maps
Default CoS-to-DSCP Map
You use the CoS-to-DSCP map to map CoS values in incoming packets to a DSCP value that QoS uses
internally to represent the priority of the traffic. The following table shows the default CoS-to-DSCP map. If
these values are not appropriate for your network, you need to modify them.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
568
Information About QoS